Metallurgical and Sinking equipment Division manufactured and success-fully tested two additional straightening-drawing machines at Novokramatorsky Mashinostroitelny Zavod.
Such equipment is installed in the technological line of continuous billet casting machine (CCM) and is intended for drawing out of the mold and subsequent straightening of a square billet with a cross section from 100×100 to 150×150 mm, at a temperature about 850˚С. The design and workmanship of the straightening-drawing machine produced by NKMZ ensure its performance in such difficult conditions.
During designing, NKMZ specialists used the significant experience gained during creation of straightening-drawing machines of their own design. As a result, the design of the machine roller drive was changed, making possible to increase significantly its reliability and overhaul interval. Metallurgists had opportunity to convince in these advantages based on their own experience, because two straightening-drawing machines of such type made by NKMZ were supplied to them.
Press-service of NKMZ